Post Jobs


When the motherboard detects CPU is running programs, it will speed up CPU automatically to make the program run smoothly and faster. Microsoft is a registered trademark of Microsoft Corporation. Otherwise, the loss of data may occur during transmission. While booting up, the BIOS version is shown in the 1st line appearing after the memory counting. The connector location and pin assignments are as follows: However, the same type and density memory modules are necessary while using dual-channel DDR, or unstability may happen. If set to [Monitor], any activity detected on the specified hardware peripherals or components will wake up the system or prevent the system from entering the power saving modes.

Uploader: Mazuhn
Date Added: 8 September 2012
File Size: 21.24 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 65829
Price: Free* [*Free Regsitration Required]

Even though MAT is easy to use, it doesn’t mean there’s no risk at all.

MSI P Neo-V Motherboard Ahci raid – Questions (with Pictures) – Fixya

Place the power cord such a way that people can not step on it. We recommend you to check if your memory is able to bear MAT setting or not before deciding to always use it.

Once the password is disabled, the system will boot and you can enter Setup without entering any password. Follow the instructions below to clear the data: Please refer to the following for details: Any attempt to operate beyond product specifications is not recommended. Suspend Time Out Minute If system activity is not detected for the length of time specified in this field, all devices except CPU will be shut off.

See Also  DELUX K8000 DRIVER

Otherwise, the loss of data may occur during transmission. LAN jack Optional 848pp When adding or removing expansion cards, make sure that you unplug the power supply first.

You must type the password to power on the system. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board.

MSI 845E Max2 User Manual: Ata133 Raid Connectors: Ide3 & Ide4 (optional)

Monitor function is available only if there is hardware monitoring mechanism onboard. Remember to disable Spread Spectrum neo-b you are overclocking because even a slight jitter can introduce a temporary boost in clock speed which may just cause your overclocked processor to lock up.

Our products are under continual improvement and we reserve the right to make changes without notice.

Do not leave this equipment in an environment unconditioned, storage temperature above 60 0 C 0Fit may damage the equipment. Mic is a connector for microphones.

Alternatively, please try the following help resources for further guidance. Do not place anything over the power 848l. You can plug the USB device directly into the connector. Setting options are described below.

Mounting h 6 mounting holes. Therefore, the description may be slightly different from the latest BIOS and should be held for reference only. The system will boot neeo-v the selected device.

This gives you an opportunity to move data from a hard disk that is going to fail to a safe place before the hard disk becomes offline.


Ata Raid Connectors: Ide3 & Ide4 (optional) – Msi E Max2 User Manual [Page 34]

These connectors support the provided IDE hard disk cable. S3-related functions described in this section are available only when your BIOS supports S3 sleep mode. Even though the Dynamic Overclocking Technology is more stable than manual overclocking, basically, it is still risky.

While booting up, the BIOS version is shown in the 1st line appearing after the memory counting. It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. Option Description [Setup] The password prompt appears only when end users try to run Setup. T is a utility that monitors your disk status to predict hard disk rwid.

The selection will raix make changes to the settings in the BIOS setup utility, so next time when you power on the system, it will still use the original first boot device to boot up. Any changes made to this setting may cause a stability issue, so changing the DDR voltage for long-term purpose is NOT recommended.